赵鹏程,刘紫静,于涛,李玲莉,胡光,石延超,程哲.自然循环铅冷快堆无保护瞬态分析研究[J].南华大学学报(自然科学版),2018,32(3):18~26, 64.[ZHAO Pengcheng,LIU Zijing,YU Tao,LI Lingli,HU Guang,SHI Yanchao,CHENG Zhe.Transient Analysis on Unprotected Transients of A Natural Circulation Lead-Cooled Fast Reactor[J].Journal of University of South China(Science and Technology),2018,32(3):18~26, 64.]
自然循环铅冷快堆无保护瞬态分析研究
Transient Analysis on Unprotected Transients of A Natural Circulation Lead-Cooled Fast Reactor
投稿时间:2018-03-18  
DOI:
中文关键词:  小型自然循环铅冷快堆  无保护超功率  无保护失热阱  无保护超功率叠加失热阱  固有安全性能
英文关键词:small natural circulation lead-cooled fast reactor  UTOP  ULOHS  UTOP & ULOHS  inherent safety performance
基金项目:
作者单位E-mail
赵鹏程 南华大学 核科学技术学院,湖南 衡阳 421001 zhaopengcheng1030@163.com 
刘紫静 南华大学 核科学技术学院,湖南 衡阳 421001
中国原子能科学研究院,北京 102413 
 
于涛 南华大学 核科学技术学院,湖南 衡阳 421001  
李玲莉 南华大学 核科学技术学院,湖南 衡阳 421001  
胡光 南华大学 核科学技术学院,湖南 衡阳 421001  
石延超 南华大学 核科学技术学院,湖南 衡阳 421001  
程哲 南华大学 核科学技术学院,湖南 衡阳 421001  
摘要点击次数: 1276
全文下载次数: 966
中文摘要:
      基于系统分析程序ATHLET建立了100 MW小型自然循环铅冷快堆一回路主冷却系统分析模型,对超功率(UTOP)、失热阱(ULOHS)和超功率叠加失热阱(UTOP & ULOHS)这三类典型无保护事故分别进行了研究.结果显示:对于UTOP,燃料芯块和包壳的温度均先增大后减小,峰值温度小于安全限值并于700 s后达到新的稳态,反应堆热工安全裕量较小.对于ULOHS,反应堆在事故后400 s内实现了自动停堆,燃料芯块和包壳温度均远低于设计限值.对于UTOP和ULOHS叠加事故,反应堆的响应特性在事故初期与UTOP相似,在事故后期与ULOHS相似,且包壳最终稳定温度较UTOP更高,反应堆热工安全裕量最小.
英文摘要:
      In order to investigate the inherent safety features of the natural circulation lead-cooled fast reactor,the primary cooling system analysis model for a natural circulation lead cooled fast reactor named SNCLFR-100 was established with ATHLET code.Unprotected transient overpower (UTOP),unprotected loss of heat sink (ULOHS),unprotected transient overpower and loss of heat sink (UTOP & ULOHS),the three typical unprotected transient conditions were selected and analyzed.The analysis showed that,during the UTOP process,though the temperatures of fuel pellet and cladding increases first and then decreases,they are still below the safety limits and stabilize again after 700 s,and the safety margin is small.As for the ULOHS,the reactor shuts itself down with the help of various types of core negative feedback,fuel pellet and cladding temperatures are far below the design limits.With regard to the UTOP & ULOHS,the response characteristics of the reactor are similar to UTOP at the beginning of the transient,and similar to ULOHS at the end of the accident,but the final stable temperature of cladding is higher than UTOP,the safety margin of the reactor is minimal.
查看全文  查看/发表评论  下载PDF阅读器
关闭